DC 12V-40V 13KHZ Auto PWM DC Motor Speed Regulator Governor Speed Controller Switch 10A 50V 1000uF

Description
This governor is extremely advanced in technology, has high efficiency, large torque, and small heat generation, has been revamped many times, and has been widely used in industrial production.


Product features:
1. 50V1000uF large capacitance. Compared with other kinds of governor 100-220uF capacitance value advantage is obvious.
2. Power tube using IRF3205 this big cow, absolutely no worries about bringing your motor. (Parameters drain current Id large value: 82A; voltage Vds maximum: 75V; open-state resistance, Rds (on): 0.013ohm).
3. Terminals use 8500 high current terminals, labeled 300V20A!


Technical parameters:

1. Input voltage: DC 12V-40V
2. Power: 0.01-400W
3. Current: rated current 8A, large throughput current 10A, quiescent current 0.02A (standby state)
4. Frequency: 13khz
5. PWM pulse width speed regulation range: 10%-100
6. With a 10A fuse, with a power reverse connection, control voltage over-voltage protection function.
7. With high-quality potentiometer
8. If you need forward and reverse functions, customers can connect the forward and reverse switch by themselves.


Product specification:

1. Size: 60*55*28mm, four positioning holes are 5mm from the edge of the board, and the diameter of the positioning holes is 3.2mm.
2. Weight: 69g
3. On-board 10A fuse, fuse is 5*20mm standard size.


Connections
1,DC+(Power+):accessible DC power supply 12-40V
2, DC-(Power-): connect to the negative pole of the DC power supply
3, Motor+(Motor+): connect to the positive pole of the control motor.
4, Motor-(Motor-): connect to the negative pole of the control motor.

- Special reminder DC motor speed controller input is DC voltage, not directly connected to the AC power (eg: household 220V AC), otherwise it will burn out!

Notes:
1, DC motor speed controller input is DC, not directly connected to AC power (eg: household 220V AC), otherwise, it will burn out!!!!
2, DC power supply positive and negative terminals do not reverse, otherwise, the governor may be damaged.
3, the motor can not be divided into positive and negative, when the running direction is inconsistent with the expectations, you can adjust the wire sequence to change the direction 4, adjusting the potentiometer knob can change the output duty cycle of the governor, the motor speed to change the wiring, the line must not touch the heatsink.
5, potentiometer clockwise adjustment, the greater the value of